Installing a Ford Transmission in your car or truck seems like a big job, and it is. Whereas you do not need to be a grasp mechanic to carry out this operation, it will take endurance, know-how and plenty of elbow grease. With the right equipment, tools and a helper, a ford transmission could be put in in a day by anybody with some mechanical aptitude, a working data of the autos’ drive train and the power to carry out some heavy lifting. Assuming you’ve already removed the old ford transmission, placing the brand new one again in should not be too difficult.
Ford Transmission Installation Procedures
1. Set the parking brake, put in your security glasses and use the jack to lift the front finish of the Ford high sufficient that the transmission might be slid beneath upon getting set it on the jack stands.
2. Place jack stands below the body within the entrance, making sure to give your self enough room to get at the transmission. Carefully decrease the front onto the jack stands.
3. Jack up the rear of the vehicle to the same height because the entrance and place jack stands under the body in the rear. Carefully lower the rear onto the jack stands.
4. Transfer the Ford Transmission into place beneath the vehicle. Watch out to not injury the underside of the transmission when transferring it into place. You have to your helper to assist with this step.
5. Slide the jack subsequent to the transmission and lift the transmission up, then slide the jack beneath it. Again, you will need the help of your helper to do this.
6. Jack the transmission up and into place. This may occasionally require some cautious, minute maneuvers to clear the body and under body.
7. Use the socket set to install the bolts through the bell housing and into the again of the engine block. You may want the lengthy extension to achieve those on the top.
8. Lower the jack after which transfer it out of the way.
9. Bolt the cross member and transmission mount again into place after which bolt the mount to the transmission.
10. Bolt the drive shaft to the rear of the brand new Ford Transmission and to the rear differential.
11. Connect the ford transmission cooler strains to the radiator and any wiring harnesses to the sensors on the transmission, if applicable. You will also wish to attach the dipstick tube at the moment by placing it in place, then seating it into the aspect of the transmission.
12. Connect the transmission cooler strains to the radiator and any wiring harnesses to the sensors on the transmission, if applicable, as well as the speedometer cable and shift linkage. Additionally, you will want to connect the dipstick tube right now by placing it in place, then seating it into the facet of the transmission and bolting it into place.
13. Consult your car’s specific proprietor’s manual for the ford transmission fluid capability and pour that quantity into the ford transmission through the dipstick tube. When it is stuffed properly, start the engine, shift the transmission via all of the gears after which recheck the fluid degree before driving.
